Metabo HPT nail gun won’t drive nails all the way in However, if your air pressure is okay, then you will want to open your gun and inspect the driver blade and the piston O-ring to see which is damaged and replace accordingly. The correct pressure, therefore, is the lowest pressure that will drive the nail flush with the surface-using higher than required pressure will overstress the gun and eventually damage it. Now, the recommended air pressure is between 70 and 120 psi (5 – 8.5 kgf/cm²)-This will typically vary depending on the length of the nail you are using and the hardness of your lumber. The first and easiest step is to always check the air pressure that you are using and increase it to the recommended pressure. Your piston O-ring is damaged or worn out.You are not using the recommended air pressure.Metabo HPT nail gun troubleshooting continued… Metabo HPT nail gun has a weak drive (is slow to cycle) Regarding this, there’s no shortcut- just replace the piston O-ring– it comes with easy-to-follow replacement instructions. Now, if all the above don’t work, then what you likely have is heavily worn or completely cut piston O-ring. If the nail sizes are correct, cleaning and lubricating the feeder could help-follow the steps we have just seen above. To start with, check figure 1 above to make sure that you are using the recommended nail sizes for your gun.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |